REPROCESSING OF STYRENE ACRYLONITRILE AND THE INFLUENCE OF THE PARTICLE SIZE ON TENSILE PROPERTIES

Abstract

The purpose of this work is to determine the influence of the reprocessed polymer on tensile properties. Tested samples were obtained using the injection molding technology from the industrial unpolluted waste, which is the same material as the virgin styrene acrylonitrile (SAN). The waste was milled for further reprocessing and a mixture of different particles was obtained. This mixture was sifted to fraction differ by particle sizes. These mixtures were characterized by tensile testing at the ambient temperature. It was found that mixtures with small particles influenced the non-sifted milled mixture even though these particles contain only a small amount.

Recommended articles

END MILLS WITH PCD INSERTS INCLUDING INTEGRAL CHIP BREAKER

Ales Polzer, Tomas Trcka
Keywords: EN AW 6082 | EN AW 6061 | force loading | chip breaker | PCD

EXPERIMENTAL SHRINKAGE STUDY OF CERAMIC DLP 3D PRINTED PARTS AFTER FIRING GREEN BODIES IN A KILN

Iaroslav Kovalenko, Yuvaraj Ramachandran, Maryna Garan
Keywords: photopolymer | debinding | SLA | DLP | 3D printing

FDM FOR HIGH TECH CERAMICS ON BASE THE ZIRCONIA IN APPLICATION OF DENTAL CROWNS

Daniel Sida, Vladimir Sida
Keywords: bio application | dental crown | ceramics | 3D printing | FDC | zirconia

SEVERITY INDEX FOR VEHICLE DRIVERS AT FRONTAL IMPACT INTO RIGID BARRIER

Jozef Kmec, Stella Hrehova
Keywords: severity index (SI index) | active and passive safety | Deformation path