DESIGN AND CHECK OF THE MECHANICAL COMPONENTS BY THE PC APPLICATION

Abstract

The paper focuses especially on comparison of available programs for design and check of the mechanical components. The main aim of the paper is to analyse in the introductory part the individual programs from the perspective of content and functionality and consequently to compare the results experimentally in selected cases. The paper evaluates simplicity or complexity of work with the individual software types on the basis of input requirements [Bicejova 2016a]. The conclusion summarizes the issue and experience acquired in designing and in checking of the mechanical components. 

Recommended articles

NOISE AND STEP HEIGHT PERFORMANCE OF SELECTED OPTICAL SURFACE MEASURING INSTRUMENTS

MATEJ HARCARIK, ROBERT JANKOVYCH
Keywords: surface texture | confocal microscopy | coherence scanning interferometry | comparison of instruments | topography measurement noise | step height repeatability

SELECTED CHARACTERISTICS AND DIAGNOSTICS OF MOTOR POWERED BY FREQUENCY CONVERTER

PETR NAHODIL, MILOS HAMMER
Keywords: frequency converter | parasitic current and voltage | shaft voltage | capacitive current | technical diagnostics | FFT spectrum of vibrations acceleration | vibro-diagnostics

SAFETY OF THE WATER SUPPLY SYSTEM IN THE ABSENCE OF DESINFECTION RESIDUE

JAN RUCKA, MARKETA RAJNOCHOVA
Keywords: chlorine | disinfectant residue | water supply | undesired event | risks analysis

OPTIMISATION OF WEDM SETTINGS PARAMETERS WHEN MACHINING PURE ALUMINIUM USING THE DOE

KATERINA MOURALOVA, JIRI KOVAR, TOMAS PROKES, JOSEF BEDNAR, PAVEL HRABEC
Keywords: EDM | electrical discharge machining | design of experiment | P-parameters | root mean square deviation of the primary profile Pq | pure aluminium