ANALYSIS OF BAR FEEDING INTO THE DRAWING TOOL

Abstract

The paper deals with a study of buckling behaviour of a bar, which is fed into the drawing tool in the production of drawn bar. When the undrawn bar is inserting into the two-die drawing tool by using hydraulic feeding collets, it can be buckled and stuffed between dies. Accordingly, basic parameters, such as a maximum possible buckling length, have to be found. Due to a specific shape of the drawn bar face, but also due to other parameters, the usage of basic equations for the calculation of buckling stability is questionable. Therefore, the numerical simulation in the ANSYS software was used. Based on basic calculations, numerical simulations and practical experiments, conditions under which the current bar feeding method can be used is found, followed by results comparison.

Recommended articles

LASER INDUCED DAMAGE THRESHOLD OF SILICON WITH NATIVE AND ARTIFICIAL SIO2 LAYER

Juraj Sladek, Inam Mirza
Keywords: SiO2 thin film | Gaussian beam | silicon damage threshold | laser spot size | ultra-short laser ablation

KERR LENS MODE-LOCKED THIN DISK OSCILATOR DEVELOPMENT AT HILASE

Martin Cimrman, Martin Smrz
Keywords: high power laser | Kerr lens | laser oscillator | Yb:YAG | femtosecond laser | mode locking | Thin disk laser

RESONANTLY ENHANCED FREQUENCY DOUBLING OF A CONTINUOUS-WAVE YTTERBIUM-DOPED FIBER LASER

Lukas Roskot, Martin Smrz, Ondrej Novak, Taisuke Miura
Keywords: periodically poled lithium niobate | enhancement cavity | frequency doubling | fiber laser

HYDROXYAPATITE AND ZINC OXIDE BASED TWO-LAYER COATING, DEPOSITED ON TI6AL4V SUBSTRATE

Leonid Sukhodub, Anton Panda, Luidmila Suchodub, Mariia Kumeda, Konstantyn Dyadyura, Iveta Pandova
Keywords: coating | alginate | zinc oxide | hydroxyapatite | Thermal substrate deposition