DRAFT DESIGN SOLUTION FOR AUTOMATED 3D SCANNING OF PERSONS

Abstract

This article deals with a process of designing an inexpensive device for automated scanning of people and large objects. The attention is paid to selection of technical solution of individual system components, from construction to calculation for motors of individual movement axes. The result is a device that allows automated digitization of objects with up to two metres of height, using simple and affordable hand-held scanners.

Recommended articles

ANALYSIS OF THE FLAME FRONT GEOMETRY RESPECT TO THE NOX FORMATION

Andrii Kulikov, Miroslav Rimar, Marcel Fedak, Olha Kulikova
Keywords: Boiler | burner | heating | natural gas | ANSYS

ANTENNA-LIKE EFFECT INDUCED BY SURFACE DEFECTS UPON ULTRASHORT LASER NANOSTRUCTURING OF SILICON

Chiara Liberatore, Jan Hrabovsky, Inam Mirza, Alexander Bulgakov, Nadezhda Bulgakova
Keywords: ultrashort laser pulses | silicon | surface defects | antenna-like effect | light scattering | periodic nanostructures

THERMOELASTIC RESPONSE OF METALS AT DIFFERENT LOADING RATES

Radek Prochazka, Sylwia Rzepa, Pavel Konopik
Keywords: thermoelasticity | thermoelastic stress analysis (TSA) | loading rate effect

NARX-NN MODEL OF 2-DOF ROBOT ARM DYNAMICS DRIVEN BY FLUIDIC MUSCLES

Monika Trojanova, Alexander Hosovsky
Keywords: Fluidic Muscles | Planar Robotic Arm | identification | NARX (Nonlinear Autoregressive Exogenous) | MLP (Multilayer Perceptron Network) | System Identification Toolbox