INNOVATION OF THE GAS MELTING FURNACE MONITORING SYSTEM

  • 1Department of Automotive and Manufacturing Technologies Faculty of Manufacturing Technologies of the Technical University of Kosice with a seat in Presov, Presov, SK

Abstract

There are increased demands for safe, reliable and economically efficient operation of modern technical devices nowadays. These technical devices need an appropriate monitoring system in order to fulfil all the requirements. This consequently monitors their activity while providing appropriate information on operating parameters. As a result of them, the control system of a technical device can perform adequate interventions to remove unstable or rather critical condition. Melting furnaces are among devices where the current state of their operation is inevitable to monitor. The monitoring of melt temperature is an inevitable requirement in these devices because of its optimization for casting process, i.e. in order not to degrade its quality due to low or high temperature. Therefore, the aim of the paper is to describe a proposal for a solution of the operating parameters of the gas melting furnace KOV 010/1998, which is in practice used for melting of non-ferrous metals with low melting point. By implementing the proposed solution, its operation should be simplified and more importantly, its operation should be more efficient.

Recommended articles

THE RESULTS OF THEORETICAL AND EXPERIMENTAL STUDIES OF TRIBOTECHNICAL PURPOSES COMPOSITES ON THE BASIS OF EPOXY COMPOSITE MATERIAL

Anton Panda, Konstiantyn Dyadyura, Petro Savchuk, Vitalii Kashytskyi, Viktoria Malets, Jan Valicek, Marta Harnicarova, Iveta Pandova, Lukas Androvic, Milena Kusnerova
Keywords: mechanical properties | thermal vacuum technology | molding | adhesion | Polymer composites

PLUNGER PRESSING SPEED LIKE THE MAIN FACTOR INFLUENCING OF THE MECHANICAL PROPERTIES OF DIE CASTING

Stefan Gaspar, Jan Pasko
Keywords: mechanical properties | plunger pressing speed | die casting

DESIGN PROPOSAL OF DIMENSIONS OF SLOTS BY DIGITALIZATION OF STANDARDIZED DIMENSIONS OF KEY

Luba Bicejova, Slavko Pavlenko
Keywords: hub | tight keys | Applications

EXPERIMENTAL RESEARCHES OF THE PULSE GAS BARRIER FACE SEAL

Eduard Kuznetsov, Anton Panda, Volodymyr Nahornyi, Sitlana Vashchenko, Olga Aleksenko, Iryna Baranova, Iveta Pandova
Keywords: flow rate characteristics | pressure distribution | sealing rings | barrier gas | impulse seal