EXAMINATION OF COOLING SYSTEMS IN MACHINE TOOLS REGARDING SYSTEM STRUCTURE AND CONTROL STRATEGIES

Abstract

When analyzing machine tools it is observable that despite sufficient cooling capacity thermo-elastic deformation of the machine structure is badly compensated due to heat input. The reason is the missing adaption of coolant and heat input into the system structure during the process, resulting in insufficient productivity and quality. In this paper, various system configurations are shown that can be used to achieve both adequate thermal performance and a reduction in energy consumption.

Recommended articles

A NOVEL DESIGN CONCEPT FOR A THERMALLY STABLE LINEAR SCALE USING TWO DIFFERENT MATERIALS

T. H. Lee, H. Gim, S. Oh, T. Gotthardt, F. Tzanetos, A. Schmetz, D. Zontar, C. Brecher
Keywords: Linear scale | Hybrid material | Thermal Behavior | Carbon fiber reinforced plastic

EFFECTS OF GRINDING WHEEL WEAR ON THE THERMO-MECHANICAL LOADS IN THE GRINDING PROCESS

M. Bredthauer, T. Bergs, S. Barth, P. Mattfeld
Keywords: CBN wear mechanisms | creep feed grinding | heat generation

IN-PROCESS MEASUREMENT AND NUMERICAL DETERMINATION OF THE TEMPERATURE IN THE CONTACT ZONE DURING SINGLE LIP DEEP HOLE DRILLING

R. Wegert, V. Guski, H.-C. Moehring, S. Schmauder
Keywords: Single lip deep hole drilling | monitoring | process temperature | in-process measurement | simulation methods

OPTIMAL POSITIONING METHODS OF INTEGRAL DEFORMATION SENSORS – EXPERT KNOWLEDGE VERSUS MATHEMATICAL OPTIMIZATION

Ch. Brecher, R. Herzog, A. Naumann, R. Spierling, F. Tzanetos
Keywords: thermal issues | Machine tool | optimal sensor positioning