COGENERATION UNIT NOISE REDUCTION BY ITS CASE

  • 1Department of Control Systems and Instrumentations, VSB-Technical University of Ostrava, Ostrava, CZ
  • 2Department of Materials and Technologies for Vehicles, VSB-Technical University of Ostrava, Ostrava, CZ
  • 3The Department of Vibroacoustic Hazards, Central Institute for Labour Protection – National Research Institute, Warsaw, PL

Abstract

This paper deals with cogeneration unit noise measurement by the acoustic camera. Noise is not only measured as the final number of sound power levels, but also its original location is determined with the use of the beamforming algorithm. The properties of the used microphone array are considered and numerically calculated as every different microphone array layout will measure with another resolution. From the frequency spectrum, the possible technical source is determined. The results of noise source visualization show the cogeneration unit case noise decreasing effect while also offering the possibilities for design improvements.

Recommended articles

MECHANICAL PROPERTIES OF ALUMINIUM ALLOYS AT HIGH STRAIN RATE

MIROSLAV JOPEK, MILAN FOREJT, MARTIN HARANT
Keywords: Split Hopkinson Bar test | aluminium alloy | EN AW 6082 | high strain rate | dynamic load.

POWER AND FORCE LIMITING TECHNIQUE AT COLLABORATIVE WORKPLACE

IVAN VIRGALA, ERIK PRADA, MAREK VAGAS
Keywords: PFL Technique | Collaborative Robots | ISO / TS 15066 | Transient Contact | Quasi-Static Contact

VIBRATION FORECASTING BY THE RESULTS OF SYNCHRONOUS CONTROL OF WATER LEVEL CHANGES IN SEVERAL OBSERVING WELLS

ANTON PANDA, VOLODYMYR NAHORNYI, PETER PIGULEVSKY, IVETA PANDOVA
Keywords: Vibration forecast | lunar-tidal harmonic | trend of the tidal harmonic amplitude | forecast model | shocks environment criticality.

DEVELOPMENT OF A PARALLEL GRIPPER WITH AN EXTENSION NAIL MECHANISM USING A METAL BELT

JUNYA TANAKA, NOBUTO MATSUHIRA
Keywords: Robotic hand | hardware design | manufacturing robot | nail extension mechanism | parallel gripper