PRODUCTION BY FDM METHOD RP TECHNOLOGY FROM PLA ECO-MATERIALS EXTRUDED HORIZONTALLY IN LENGTH

Abstract

The authors in their article are devoted to describe the samples production of sophisticated eco-material PLA -PolyLacticAcid extruded horizontally in length, produced by FDM method, Rapid Prototyping. Carried out experimental tests of mechanical properties are presented by the authors in this article. Also in this article eco-materials outputs tested are presented in patterns, measurement protocols recorded in software, the measured values in a static tensile test, recorded in tables and shown in work graphs. Based on obtained results the authors compared produced samples from two PLA eco-materials and determined which PLA – ecoplastic is stronger.

Recommended articles

STUDY OF GASEOUS FLOWS IN CLOSED AREA WITH FORCED VENTILATION

MIROSLAV RIMAR, MARCEL FEDAK, ANDRII KULIKOV, PETER SMERINGAI
Keywords: heat recovery ventilator | ventilation | heating | recuperation | ANSYS

EFFECT OF LOW BETA IRRADIATION DOSE ON MECHANICAL PROPERTIES OF SURFACE LAYER OF INJECTION MOULDED POLYAMIDE 11 (PA 11)

DAVID MANAS, MIROSLAV MANAS, LENKA GAJZLEROVA, MARTIN MIZERA
Keywords: Polyamide 11 (PA 11) | cross-linking | micro-hardness | micro-mechanical properties | surface layer

EFFECTS OF WATER JETS ON CNTS/CONCRETE COMPOSITE

VLADIMIR FOLDYNA, JOSEF FOLDYNA, DAGMAR KLICHOVA
Keywords: CNTs/concrete composite | continuous and pulsating water jet | material removal

DESIGN OF THE TOOL FOR PRESSING OF TARPAULIN GROMMETS

JAN ŘIHÁČEK, KAMIL PODANÝ, MAREK HUDEČEK
Keywords: tarpaulin grommet | expanding | punching | ANSYS Workbench | numeric simulation | DX51D+Z275MAC steel