MONITORING THE CONDITION OF THE SPINDLE OF THE MILLING MACHINE USING VIBRATION

Abstract

The goal of this paper is to point out the possibility of occurrence of vibration during milling due to changing depth of removed layer of the material. Growth of values of mechanical vibration in depending on the value of the nominal thickness of the splinter was monitored during changing technological parameters of the milling process due to rotation speed of the engine. The results of the experimental part are values of vibration acceleration amplitude measured by a piezoelectric sensor on the head of the milling machine. Two types of tools have been used for the measurements - a plate and a monolith milling machine and rotation speed and material removal have been changed on the selected device. Based on the analysis of created graphical dependencies a set of new knowledge, conclusions and recommendations is formulated.

Recommended articles

TEST BENCH FOR TESTING OF THE TRACTION DRIVE OF RAILWAY VEHICLES

BOHUMIL CEJKA, PETR HELLER, LUKAS TRPAK
Keywords: test bench | traction drive | torque transmission | suspension | gearbox oil leakage | fully-suspended drive | computer simulation | optimization

ANALYSIS OF THE WEAR OF SAW BLADE TEETH AND THE PROPOSAL OF METHODS OF INCREASING THEIR WEAR RESISTANCE

JOZEF KRILEK, DANIELA KALINCOVA, MIROSLAVA TAVODOVA, JAN KOVAC, ANDRZEJ PEREC
Keywords: saw blade | cutting edge | wear | tool steel | coating