PRODUCTION OF ROLLED PROFILE AND ITS VERIFICATION BY USING NUMERICAL SIMULATION

Abstract

The paper deals with a manufacturing technology of hot-rolled sections. A calibration system proposal of the solved section is described and its accuracy is subsequently verified by numerical simulation using Simufact Forming software. In this case, S355J2 steel is used as a material for a trial production of the rolled profile. Finally, according to the verified design, the trial rolling of the section is carried out. Therefore, a comparison between actual rolled section shapes of individual rolling passes and simulation results is performed. This makes it possible to assess the accuracy of the simulation and thus the suitability for use in the development of other rolled sections.

Recommended articles

DESIGN OF SIMULATION-EMULATION LOGISTICS SYSTEM

GREGOR MILAN, ROBERT HODON, VLADIMIRA BINASOVA, LUBOSLAV DULINA, MARTIN GASO
Keywords: innovative system | logistics system | emulation | Simulation

OPTIMIZATION METHOD FOR DESIGNING OF HYDRAULIC ELEMENTS

MILADA KOZUBKOVA, JANA JABLONSKA, MARIAN BOJKO, PATRIK MARCALIK
Keywords: adjoint solver | cfd | goal function | optimization

LOAD CYCLE INVESTIGATION OF AXIAL PISTON UNITS INTEGRATED INTO A FORWARDER

IVAN BAUS, ROBERT RAHMFELD, ANDREAS SCHUMACHER, HENRIK PEDERSEN
Keywords: load assessment | drivetrain | measurement system | clustering algorithm | load cycles | axial piston unit

EFFECT OF TEMPERATURE, FLOW RATE AND CONTAMINATION ON HYDRAULIC FILTRATION

J.M.R. GORLE, V-M HEISKANEN, S. NISSI, M. MAJAS
Keywords: pressure drop | gravimetric level | flow rate | temperature | hydraulic filtration