DESIGN AND MANUFACTURE OF BENT AND VARIABLE SECTION TUBES MADE OF FRP COMPOSITE

  • 1Technical University of Cluj-Napoca Manufacturing Engineering Department, Napoca, RO
  • 2Technical University of Cluj-Napoca Mechanical Engineering Department, Napoca, RO

Abstract

Manufacturing of bent composite tubes with variable cross-section is a challenge. The traditional process in composite materials uses retractable mandrels that in case of inflated or bent tubes cannot be applied. The tubular composite elements are often used in high performance bicycles, in the manufacturing of frames, handlebars, saddle pipe supports, etc. This paper presents research on the design of a Mountain Bike (MTB) riser handlebar made of Fiber Reinforced Polymer (FRP). The handlebar is numerically analyzed to estimate the most suitable stacking sequence of Carbon Fiber Reinforced Polymer (CFRP) layers. Depending on the safety standard of bicycle handlebars, a case of longitudinal bending tests was numerically evaluated. Comparing the weight of the CFRP handlebar with the steel handlebar of the same shape, the mass reduction is 5.2 times. The obtained results indicate a two-fold reduction in the weight of the handlebar if it is compared to a handlebar made of aluminum alloys. The research also presents the manufacturing process of the composite mold, and CFRP tubular element. Prepreg CFRP materials are used to manufacture the handlebar, the employed technology being the vacuum bag forming and autoclave curing process.

Recommended articles

ANALYSIS OF THE EFFECT OF PRETREATMENT ON THE OVERALL DAMAGE OF THE COATING CREATED BY THE CATAPHORETIC COATING

M. GOMBAR, P. FEJKO, J. DOBRANSKY, L. STRAKA
Keywords: aluminum | surface treatment | cataphoretic coatings | quality of surface | degreasing solution