VERIFICATION OF THE MICROSCOPE CALIBRATION RULER

Abstract

The article deals with the methodology of verification of the calibration ruler for the microscope. These calibration rulers are used for the calibration of measuring microscopes and are therefore always supplied without a calibration protocol. However, it is necessary to find a way to determine the measurement uncertainty when using a measuring microscope.

Recommended articles

ANALYSIS OF THE INFLUENCE OF ARC LENGTH AND DYNAMICS CORRECTION ON THE DIMENSIONAL CHARACTERISTICS OF WELD OVERLAYS USING THE DOE METHOD

Milan Maronek, Bohdan Savytskyi, Jozef Barta, Janette Kotianova
Keywords: WAAM | DOE | Arc length | Dynamics correction | Dimensional characteristics